v10.4 [Feb 20, 2014]
GENERAL CHANGES:
- Imported Schneider MiCOM P124 overcurrent relay curves into the relay database.
- Fixing issue opening PDBxml files for torkel/bvm form.
- Allow user to set pen width for grid lines on both regular grids and polar grids.
Set arrowhead text for printing.
- MCT - Fixed issue when using "," as decimal symbol.
- removing bad splash screen.
- Updating French Canadian translations.
- Move s1 instrument back to 6.0.
- And wild card on included subforms.
- Included STVI full help for French and Spanish.
- Correctly parse PfcType values for PFC_IRIG and PFC_TRANSDUCER availability.
- Added SMRTCMD_DIRECTDRAW to cmd enum for RunCmd().
- StartTransducerTest():Save settings before metering and restore them afterward.
- ResetVectors() then ApplyVectors() to make sure that the values are sent to the test set (this was originally happening as a result of being in Online mode, but didn't work after we set that we were running a test.)
- Loop and meter while the values are being applied.
- GetSMRTInfo(): When parsing the new "QCxx;" command's response, check the response from the query (instead of the old response) to see if there is more data that needs to be queried.
- Fixing MTO preferred model registry setting for lite/advanced.
- Fixing MTO row selection dialog dropdowns for embedded.
- Fixing release candidate popup for embedded.
- fixing interactive charts that did not print correctly.
- changing zoom and sequence to sendmessage rather than post
- Removing MTO instrument configuration dialog from lite and advanced.
- Re-enable selecting all phases in MTO heat run wizard.
- Use send message not post message when sequencing/zooming on ping.
- Change to add additional columns to language table when language is not found.
An application that enables you to add port forwarding entry into your router.
Allows manual or semi-automatic processing of structured documents filled-in.